Session 400 sometimes not in session.

Dwight Lewis · From: Huntsville, Alabama

I have a session 400 that seems to lose its gain until you turn it up full blast and strung the strings to wake it up, which wakes up pretty much everything within a 5oo ft radius. I have a brother that has a 500 that does the same thing, and there is a key board amp at church (Peavey also) that does the same thing. Anyone ever have this issue and what can fix it.

Thanks

ijaash@yahoo.com
_________________
Dekley 7p4k(PRS-10C), BMI S12 5p5kn

Nic du Toit · From: Milnerton, Cape, South Africa

Dwight,
check your mail.
_________________
1970 P/P Emmons D10 flatback 8x5, BJS Bar, J F picks, Peavey Session 500, Telonics pedal. Boss GX700 effects.
Skype : nidutoit

Donny Hinson · From: Glen Burnie, Md. U.S.A.

Most likely, it's dirty jacks or molex connectors in the amp. And usually, the proper fix is to take it apart and clean/re-tighten them. (A cold solder joint can also cause the same problem , but it's not nearly as common.)

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: