| Author |
Topic: Emci |
Eddie Juke
From:
United Kingdom
|
Posted 4 Jul 2009 12:02 pm |
|
Hi everyone
I would like to put a couple of additional pulls on my EMCI, I would like to raise the 7th string F# to G on a RKL and a B to Bb on a LKV so I need all the parts to do this, who may possibly have these EMCI parts or parts suitable to do the job, I am also looking for a bracket to fit on the pedal bar so I can use an Emmons volume pedal with a fixed pin, all help will be greatly appreciated,
Regards
Eddie |
|
|
 |
Micky Byrne
From:
United Kingdom (deceased)
|
Posted 4 Jul 2009 3:35 pm Re: Emci
|
|
Eddie, contact Bud Carter, he was the designer of the EMCI then went off to design the Carter. I'm sure he will help you out...903-778-2051 ..That's his number.
Micky Byrne United Kingdom
www.micky-byrne.co.uk |
|
|
|
Bob Hoffnar
From:
Austin, Tx
|
Posted 4 Jul 2009 3:53 pm
|
|
If I remember right Pedalmaster steel guitar parts should work in that guitar. Also Jim Palenscar at
http://steelguitarsofnc.com/dotnetnuke/
should be able to help. He has rebuilt quite a few EMCI steels.
What you are talking about is a very easy job you should be able to handle with the right parts and a little advise.
_________________
Bob |
|
|
|
Paddy Long
From:
Christchurch, New Zealand
|
Posted 5 Jul 2009 6:20 pm
|
|
I think Jim Flynn at Lonestar Steels might be worth a call too -- he uses MCI fretboards and bits for his steels if I remember correctly. Try this:
http://www.lonestarsteelguitar.com/services.html
_________________
14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases. |
|
|
|
Eddie Juke
From:
United Kingdom
|
Posted 6 Jul 2009 8:49 am Emci
|
|
Thanks to all of you for your replies, I am just pursuing all avenues, Micky I am waiting for John Fabian to reply
Regards
Eddie |
|
|
|
Anthony Vandewalle
From:
Hawks Nest, NSW, Australia
|
Posted 8 Jul 2009 7:14 pm Emci
|
|
| Eddy, I have an EMCI and am thinking of making the same changes. Were you able to locate parts? |
|
|
|
Brick Spieth
From:
San Jose, California, USA
|
Posted 9 Jul 2009 3:24 pm
|
|
| Jim Palanscar replaced a knee lever on my EMCI before he shipped it to me, so I know he can do what you want. |
|
|
|
Eddie Juke
From:
United Kingdom
|
Posted 1 Aug 2009 11:33 am emci
|
|
Sorry for not replying sooner, contact Jim Palenscar he has all the parts you require, my parts have arrived exactly as I asked for
Eddie |
|
|
|
