Dan Burnham
From:
Greenfield, Tennessee
|
Posted 11 Jul 2004 8:45 pm |
|
Hey Guys for you folks needing Sierra Parts I have had machined, Bell Cranks, complete pull units, and etc., from my Sierra 2003.
These parts are not cheap, but are available. I'm only marking up $1.00 - $2.00 on each part to mess with it if anybody is interested. I'm turning my 12 String Extended into a Universal 12 so I can get anything machined at this time needed. Please check my site for pics of parts. www.sidestreetsteel.com
If there is something you need machined and are willing to pay for it I can get any of it done just let me know,
Thanks, keep picking!
|
|
Scott Swartz
From:
St. Louis, MO
|
Posted 12 Jul 2004 8:41 am
|
|
I had some Sierra rods made at a local machine shop a few weeks ago, and Dan's pricing is very reasonable based on my experience.
I think bellcranks were $15-20 and rods $6-10 direct from Sierra (I bought some in 2002), so a doubling of the price for a low volume run is perfectly reasonable and expected.
|
|
