NV112 Volume Control

Doug Rolfe · From: Indianapolis, IN

I have a new NV112 that was only used at our recent show and when I got it home the volume knob had been broken off, I guess in the handling by someone. How difficult is it to change this control?

Jack Stoner · From: Kansas City, MO

Not much different than other Peavey's, if I remember correctly (I just had the chassis out of my NV112). The pot is mounted (soldered) to the preamp circuit board, so all of the mounting nuts for all the controls will have to be removed, along with whatever mounting so you can get the preamp board in position to unsolder and solder in a new pot.

Your best bet is to order the pot from Peavey so you have the exact replacement. Peavey's replacement parts are very reasonable.

Jim Eaton · From: Santa Susana, Ca

Doug, I sent you an e-mail that you might find helpful with this problem.
Anyone else with a Nashville 112 that would like to find out how to protect the knobs so this does not happen to your amp, send me an e-mail and I'll show ya what I'm talking about.
JE:-)>

------------------
Emmons D10PP 8/4 -75'
Emmons SD-12PP 3/4
Zum SD-12 5/5 - 91'
76'Session 400
86'Nashville 400
06'Nashville 112 x 2

[This message was edited by Jim Eaton on 07 July 2006 at 02:23 PM.]

Jim Eaton · From: Santa Susana, Ca

Doug Rolfe · From: Indianapolis, IN

Thanks guys. I appreciate it. Normally I do my own loading and unloading and it's not a problem. I'm not sure how this happened, but someone picked it up and the next thing I knew was the knob was on the floor of my truck.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: