| Author |
Topic: Pre amp hook up (HELP) |
Will Aytes
From:
Bartow, Florida, USA
|
Posted 19 Apr 2005 4:42 am |
|
I need some help with the line hookup, I just purchased a Tube Works 9002 Pre Amp from a fellow forum member and he doesn't remember how he had it hooked up. I was wondering if anyone could help with proper line hookup and settings. I down loaded a manual but it does not specifically tell which line goes where, and I am electronics challenged to say the least. Any assistance guys would be appreciated.
Thanks Up Front
Regards
Will
------------------
Mullen D-10 HWP 8&5, Zum U-12 7&5 Transtube Fex, Nashville 400
|
|
|
 |
Jack Stoner
From:
Kansas City, MO
|
Posted 19 Apr 2005 5:22 am
|
|
Will, I had one for a while.
Line out A is for either mono or if you have a stereo power amp, connect Line out A to one channel (e.g. Left channel) and Line Out B to the other channel.
There's also an effects loop that will handle "line level" effects such as many Lexicon and T.C Electronic rack units.
The on-line manual I have is pretty straightforward.
|
|
|
|
Will Aytes
From:
Bartow, Florida, USA
|
Posted 19 Apr 2005 3:19 pm
|
|
Thanks Jack, got it done.
This sure does add some warm tone to my rack system.
Close this up Bob
Thanks Again
|
|
|
|
