| Author |
Topic: Webb 614 E speaker compatibility |
Ray DeVoe
From:
Hudson, FL
|
Posted 9 Feb 2005 2:08 pm |
|
Hi. I just purchased my first Webb and have a question as to speaker compatibility. The back of the amp states 225 watts output at 4 ohms. The 2 speaker out jacks have written between them 2, 4, and 8, ohms. I'm sure any Webb owner can answer this. Does this amp have a circuit that changes to where it puts out the same 225 watts at whatever ohm load??
Thanks for any enlightenment that you can provide me on this. I have a JBL K 130, 8 ohm speaker that I was planning on installing.
Thanks
Ray |
|
|
 |
Jay Ganz
From:
Out Behind The Barn
|
Posted 9 Feb 2005 2:16 pm
|
|
If you install an 8 ohm speaker in the Webb,
it will put out approximately 160 watts rms.
You won't notice any difference in volume, but
it will break up a little sooner when you
really crank the amp way up. |
|
|
|
Ray DeVoe
From:
Hudson, FL
|
Posted 9 Feb 2005 4:20 pm
|
|
Thanks Jay for your help.
I also sent you an e mail concerning the above but with a little more detail.
Thanks again
Ray |
|
|
|
