Zb Custom Amp

Bill Cook · From: Montgomery, Alabama, USA (deceased)

Did Zane Beck make an amplifier? If so, does anybody know about them? Thanks, Bill.

Jim Smith · From: Midlothian, TX, USA

I don't know anything about them, but there was one on eBay a few days ago. It might still be there.

Brad Bechtel · From: San Francisco, CA

Jay Dee Maness · From: North Hills, CA

These amps were made by Standel Co. They made amps for Gibson also. I had two of them back in the 70s and early 80s, pretty much wore them out doing sessions with them.By the way, the Gibson models looked a lot the same as the ZBs. JayDee

Dave Van Allen · From: Doylestown, PA , US , Earth

Jay Dee...so they sounded good for sessions I gather?
was the wearing them out 'cause you used them so much or 'cause they were shoddily constructed?

both?

neither?

[This message was edited by Dave Van Allen on 16 October 2003 at 10:35 AM.]

Bill Cook · From: Montgomery, Alabama, USA (deceased)

Jim, Brad, Jay Dee, Thanks very much for the Help. The one on e bay looks like it has been rode hard and put up wet!!!!!!!Thanks Guys. Bill.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: