Raul Huerta
From: Cuauhtemoc, Chihuahua, Mexico
|
Posted 13 Jan 2003 7:35 pm
|
|
Can Anyone tell how is the conection circuite of the output and input Patch for get the best sound of my guitar , I have a Nash 400, Ernie Ball Volumen Pedal & Boss DD-3 efects.
thanks friends.....Raul |
|
Mike Brown
From: Meridian, Mississippi USA
|
Posted 14 Jan 2003 7:10 am
|
|
Hello Raul,
I suggest that you use the 3 cord volume pedal hookup. The hookup is as follow; connect cable #1 direct from the output of your guitar to input #1 of the Nashville. Next, connect the second cable from the SEND jack to the input of your volume pedal. Using the third cable, connect from the output of your pedal to the RETURN jack in the PRE EQ PATCH section of the amp.
I would either try placing the DDL-3 between the guitar output and amp input, or use the backpanel PREAMP OUT and route to the input of the pedal, then using another shielded cable, connect from the output of the pedal to the POWER AMP IN on the rear panel of the amp.
Hope that this works for you. |
|