Wade Terral
From:
DeKalb, Tx USA
|
Posted 1 Aug 2001 5:34 pm |
|
Hi Mike,
I have a Tubefex and DPC1000. Ihad it on for about an hour last night, everything was going fine then the A chanel cut out and started buzzing. I switched the cables from the T-fex(A&B) and it remained the same, then switched cables on the DPC1000 and the buzz changed speakers, so I assume it is the amp. The signal light on the amp remains red. Think I need to bundle it up and send it home?? Thanks, Wade |
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 2 Aug 2001 6:45 am
|
|
Hello Wade,
Thanks for using Peavey products. Make sure that this problem is not caused by a cable even though you swapped them between channels. Other than that, our tech states that a service tech needs to bench check it. If you wish to send it to the factory, send it with a note of symptoms(or print off this post) to;
Peavey Service Center
Hwy. 80 East
Meridian, MS 39301
Thanks. |
|
