| Author |
Topic: Fender badge on Stringmaster |
Alex Cattaneo
From:
Quebec, Canada
|
Posted 20 Sep 2024 4:55 am |
|
Time to re-attach the Fender logo on my Stringmaster. When I got the guitar, this was attached to the front of the guitar, where the decal usually goes! I know where to set it from pictures, but I was wondering if these are the right screws? Maybe someone knows (Tony Oresteen?) or could post some some close-up pictures of the badge on their unmolested Stringmaster.
 |
|
|
 |
Nathan Laudenbach
From:
Montana
|
Posted 20 Sep 2024 6:04 am
|
|
| For what it’s worth, the badge on my Dual Pro is attached with small nails. |
|
|
|
Miles Lang
From:
Venturaloha
|
Posted 20 Sep 2024 6:25 am
|
|
Small nails on my ‘66 Stringmaster
_________________
Santo Fan Club - from the island of Coney to the sands of Rockaway
Jill Martini & The Shrunken Heads
All aloha, all the time |
|
|
|
Joe Burke
From:
Toronto, Canada
|
Posted 20 Sep 2024 6:48 am
|
|
Looks like right in the middle on mine.
 |
|
|
|
Joe Burke
From:
Toronto, Canada
|
Posted 20 Sep 2024 6:49 am
|
|
 |
|
|
|
Chris Clem
From:
California, USA
|
Posted 20 Sep 2024 8:42 am
|
|
| They are called Escutcheon pins. They come in many sizes,Nickel plated or solid Brass etc......They are cheap on Ebay or any hardware supply . The key is figuring out the size you need. It should go into the wood about 1/2 inch. Pre-drill the hole just slightly smaller then the shaft size. |
|
|
|
Alex Cattaneo
From:
Quebec, Canada
|
Posted 20 Sep 2024 9:49 am
|
|
I knew those screws looked wrong!
Thanks guys! |
|
|
|
Per Berner
From:
Skovde, Sweden
|
Posted 20 Sep 2024 10:29 am
|
|
| Looks like the holes on your badge have been enlarged (to fit the screws). Might make it difficult to fit the badge using the pins, which look a lot smaller anc may not cover the holes. |
|
|
|
