BMI Replace Pin in bridge roller

James Quillian · From: San Antonio, Texas, USA

Would one of the metal dowels in the image below work as a replacement for the one that bends?

Also, any guesses as to the diameter it should be?

This photo is of the pin that bends.

x
_________________
Curbside Jimmy's New Act
https://www.youtube.com/watch?v=XlzieFLE5no

Bobby D. Jones · From: West Virginia, USA

The chuck end of a proper size broken drill bit makes a good pin, Will not bend.
Grind to cut and smooth end, To go in finger. Epoxy if it is not a good tight fit.

Charlie Hansen · From: Halifax, NS Canada and Various Southern Towns.

Try a 5/64 roll pin.
_________________
I don't know much but what I know I know very well.
Carter S-10 3X5, Peavey Nashville 112, plus Regal dobro and too many other instruments to mention.
Bluegrass Island CFCY FM 95.1 Charlottetown, PE, Canada, on the web at cfcy.fm.
A Touch Of Texas CIOE FM 97.5 Sackville, NS, Canada,
on the web at cioe975.ca.

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: