| Author |
Topic: A electronics question on MSA's |
Steven Black
From:
Gahanna, Ohio, USA
|
Posted 20 Jun 2024 8:20 am |
|
| Hello Folks, what were the ohms on the volume and tone controls of the MSA Classic's before everyone started removing them? |
|
|
 |
Mike Auman
From:
North Texas, USA
|
|
|
|
Steven Black
From:
Gahanna, Ohio, USA
|
Posted 20 Jun 2024 11:06 am Question about tone pots on MSA guitars
|
|
| Hello Mike thanks for the response, what ohms were the pots do you happen to know what they used? was it 250k or 50k? |
|
|
|
Mike Auman
From:
North Texas, USA
|
Posted 20 Jun 2024 11:26 am
|
|
According to Jim's post, he had some original pots from MSA in his shop, and they were 1 megohm linear taper (B1M) for tone, and 1 megohm audio taper (A1M) for volume.
_________________
Long-time guitar player, now wrestling with lap steel. |
|
|
|
Steven Black
From:
Gahanna, Ohio, USA
|
Posted 21 Jun 2024 7:05 am Pots for MSA's
|
|
| thanks Mike for the reply, that helps a lot. Steve Black. |
|
|
|
Bobby D. Jones
From:
West Virginia, USA
|
Posted 23 Jun 2024 3:47 pm
|
|
I owned a MSA that someone had removed the tone and volume controls. Those knobs protect that little 3 way switch that controls the necks. Broke 2 switches putting the guitar in and out of case. Added a bar of wood and bolts through volume and tone control holes.
I had a MSA S10 Classic with the volume and tone control. I could not get stage volume from the guitar. I gator clipped direct from pickup, Had great volume.
I put a 2 way switch under the guitar, Wired one leg direct, The other leg through volume and tone control. Worked great, And kept the guitar looking original, Amp. volume control set stage volume. |
|
|
|
