G-K MB 200 Sans Cabinet?

Howard Parker · From: Maryland

May have to go"ampless" for a gig. I do own a G-K MB200 with D.I.

Anyone know if the amp's design allows for running without a speaker?

hp

Howard Parker · From: Maryland

Apparently, the answer is "go for it"

From the manual:

Speaker: The power amp output to a speaker
cabinet delivers 200w into 4 Ohm loads. Lower
impedances such as 8 Ohms or 16 Ohms and no
load are acceptable.

Andy Vance · From: Graham, Washington, USA

Howard,
I did it one night when my amp went belly up and I had the MB200 in my gig bag as a backup. Worked fine without a load.

Howard Parker · From: Maryland

Mighty Fine!!

One step closer to saving my aging back.

The post EQ D.I. I am sure will be adequate for this gig. In combination with IEM individual mixes this should be just dandy.

h

Howard Parker · From: Maryland

Wanted to report back that the setup worked flawlessly, both from my perspective and from steel players in the audience.

Likey!!!

h

Ken Pippus · From: Langford, BC, Canada

Guess I don't have an excuse to run out and buy a dedicated DI box! Useful info, thanks Howard.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: