session 400 capacitors

Dave Campbell · From: Nova Scotia, Canada

i need to replace the filter capacitors in the session 400 that just found its way to me.

does anyone have a current mouser catalogue number for the correct filter. it would save me hunting.

thanks

Ken Fox · From: Nashville GA USA

5985-85-63V8200

These are what I used in my mods

Dave Campbell · From: Nova Scotia, Canada

thanks so much, ken. that's excactly what i was looking for. but...

being hotheaded i went ahead and ordered these:

https://www.digikey.ca/en/products/detail/vishay-beyschlag-draloric-bc-components/MAL205018472E3/5632741?s=N4IgTCBcDaKHAEBWAbAWgLIEEAyYAMDcBGADgBYB2MAUQGYUA5AEThAF0BfIA

i think they are very slightly less capacitance than stock (4700uf vs 5000), but given the tolerances i don't think i'm worried. do you find the higher capacitance ones you recommend tighten things up a bit?

Ken Fox · From: Nashville GA USA

Can’t say they did. But they were a bit higher capacitance and the same diameter
As the originals.

Half the length. Newer caps are more efficient and smaller than the old ones. The diameter made it a nice fit.

Ken Fox · From: Nashville GA USA

Those should be fine. Same capacitance as used in the 200 watt Nashville 400 amps

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: