| Author |
Topic: Install Fender Tilt Back Legs On A Peavey Nashville 112 |
Paul King
From:
Gainesville, Texas, USA
|
Posted 6 Dec 2022 4:40 pm |
|
| I ordered a set of the Fender tilt back legs for my Nashville 112. To my surprise there was no instructions. Just wondering if any of you steel players have installed a set on your amp. I am pretty sure any holes drilled would have to be exact. Any help would be greatly appreciated. |
|
|
 |
Karol Wainscott
From:
Kokomo , Indiana
|
Posted 6 Dec 2022 4:44 pm
|
|
| Measure hole locations off a Fender amp with the legs on it . Thats what I did. |
|
|
|
Paul King
From:
Gainesville, Texas, USA
|
Posted 6 Dec 2022 5:56 pm
|
|
| Thank you Karol. |
|
|
|
Donny Hinson
From:
Glen Burnie, Md. U.S.A.
|
Posted 6 Dec 2022 6:39 pm
|
|
| Just as a point of information, the Fender tilt-back legs come in three different lengths. The location of the holes will probably be different, depending on which ones you have. |
|
|
|
Paul King
From:
Gainesville, Texas, USA
|
Posted 6 Dec 2022 7:13 pm
|
|
| I bought the 14 inch. I have another steel player who has a template that has installed 3 sets of them. That should help me out. Sure do not want to drill into a component and mess anything up. |
|
|
|
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 7 Dec 2022 6:51 am
|
|
| Paul King wrote: |
| I bought the 14 inch. I have another steel player who has a template that has installed 3 sets of them. That should help me out. Sure do not want to drill into a component and mess anything up. |
Maybe remove the chassis if there is a chance of drilling all the way through the cabinet into the chassis. Better safe than sorry.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 54 years and still counting. |
|
|
|
Jack Hanson
From:
San Luis Valley, USA
|
Posted 7 Dec 2022 9:00 am
|
|
| Would you call a PV amp with Fender tilt-back legs a Pender, or a Feavey? |
|
|
|
David Wright
From:
Pilot Point ,Tx USA.
|
Posted 7 Dec 2022 10:10 am
|
|
Bought time Paul....easy to do, come by and we get it done  |
|
|
|
Bill A. Moore
From:
Silver City, New Mexico, USA
|
|
|
|
Paul King
From:
Gainesville, Texas, USA
|
Posted 7 Dec 2022 10:36 am
|
|
| Jack, What a wonderful question. David Wright, I have it covered but Thank You for being willing to help. My next project, get me a Harley Davidson like David Wright. |
|
|
|
