| Author |
Topic: Shielding question |
Jack Hanson
From:
San Luis Valley, USA
|
Posted 1 Nov 2022 9:00 am |
|
| I've been in the habit of shielding the pickup and control cavities in my rescue lap steels and guitars with a combo platter of adhesive aluminum foil, copper tape, and that nasty graphite paint. I've used single-coil pickups, and have achieved excellent results. Would the same method apply for shielding humbucking pickups, or is it unnecessary overkill? |
|
|
 |
Mike Auman
From:
North Texas, USA
|
Posted 1 Nov 2022 9:36 am
|
|
The same method applies. Whether it's worth the trouble depends on whether the noise bothers you, all humbuckers are not equally good at cancelling noise. Unshielded wiring runs outside the cavity can also contribute (thinking about the placement of a Tele switch in the cavity, vs. a Les Paul switch on the upper bout, for example, the LP wiring is much longer.) You can replace long runs with shielded wire.
_________________
Long-time guitar player, now wrestling with lap steel. |
|
|
|
Jeff Highland
From:
New South Wales, Australia
|
Posted 1 Nov 2022 11:32 am
|
|
Not a lot to be gained in the pickup cavity since the HB already has a grounded metal baseplate (gibson type HB). Control cavity yes, and shielded wire where possible.
_________________
Duesenberg Fairytale
1949 Supro Supreme
1950 National New Yorker
2008 Highland Baritone Weissenborn
2020 Highland New Yorker.
2020 Highland Mohan Veena
2021 Highland Weissencone |
|
|
|
Jack Hanson
From:
San Luis Valley, USA
|
Posted 2 Nov 2022 9:13 am
|
|
Thank you for your replies, gentlemen.
I currently have five instruments (two Gibson BR-9s, two Kalamazoo KG toilet seat guitars, and a Kalamazoo KB toilet seat bass) that I am in the process of rescuing from dead carcasses. All of them have the pickup(s) and controls in the same cavity. One KG and the KB will receive humbuckers. I reckon that I will keep doing what I have always done, and give the entire cavities three coats of that nasty black shielding paint.
 |
|
|
|
Ken Morgan
From:
Midland, Texas, USA
|
Posted 2 Nov 2022 9:30 am
|
|
Has anyone like EMG ever made an active (dead quiet) pickup for pedal or lap steels?
_________________
67 Shobud Blue Darling III, scads of pedals and such, more 6 strings than I got room for
Ken Morgan
Midland, TX |
|
|
|
George Piburn
From:
The Land of Enchantment New Mexico
|
|
|
|
