67 S10 Emmons cut tail 3x5 sold

Rich Gibson · From: Pittsburgh Pa.

I got this from Johnny King sept of 19 and played about a doz gigs till things shut down.Hasnâ€™t left my music room since.
Tommy Cass rebuild
Hereâ€™s a link to discussion of the guitar when I bought it including verification from Tommy.
https://bb.steelguitarforum.com/viewtopic.php?t=349258&highlight=emmons+s10
Emmons set up Eâ€™s on the left
I made a minor change in the RKL using a Clem Schmitz Clip on bell crank to raise 7 a half.The oringinal whole step lower on 6 is still in place just not in use.It can be easily switched.I also removed the half stop on 2 but will include it.
The pictures are from the original posting but guitar is the same.

The pedal rack is not original but is very secure.The pedals and rods are emmons

The only real cosmetic flaw is the upper adjustment holes on strings 1and 10 where enlarged at some point but are fully functional
Iâ€™m asking what I paid 2950$ plus shipping and have Johnnyâ€™s custom wooden shipping crate.I am in Pittsburgh PA and would drive a couple hrs to avoid shipping.
I will also be in Southern Pines NC in February if that would work for anyone.
No trades except for a Beard MA8 or possible Clinesmith D8 console

Tommy Auldridge · From: Maryland, USA

Rich: I wish I had inherited one of my brothers dobros. I would trade in a minute. I did inherit his steel guitas, but not his dobros. Thanks, Tommy.....

Rich Gibson · From: Pittsburgh Pa.

Ah too bad.We could have met halfway.
I know you where interested in this last time around.It’s pretty sweet.

Troy Engle · From: Pennsylvania, USA

PM sent

Forum Index > For Sale: Steel Guitars		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: