Author |
Topic: Excel Superb - Is there a trick to tuning knee levers? |
Fred Glave
From: McHenry, Illinois, USA
|
Posted 4 Jul 2021 10:05 am
|
|
I have an Excel Superb and I'm having trouble tuning the knee levers. After I finish tuning the high F# and the D string levers, the open string is then out of tune. I'm holding the levers in position when I adjust the rods. I can't find any info on this on the Excel website or in a general google search. _________________ Zum Encore, Zum Stage One, Fender 2000, Harlan Bros., Multi-Kord, |
|
|
|
Jon Light
From: Saugerties, NY
|
Posted 4 Jul 2021 10:36 am
|
|
Any time the tuning of levers or pedals results in detuning of an open string you have to suspect overtuning. See my sticky at the top of this section. |
|
|
|
Bobby D. Jones
From: West Virginia, USA
|
Posted 4 Jul 2021 12:35 pm
|
|
First thing that comes to mind, Not enough Travel on knee lever pull rods.
Are the problem strings the exact same size as before?
May take moving the pull rod on the bell crank 1 or more holes farther from the cross rod to give the pull rod more travel. Be sure to draw a diagram or take pictures of the bell crank, Before moving a bell a crank pull.
Good Luck in finding the problem and the cure and back Happy Steelin. |
|
|
|
Fred Glave
From: McHenry, Illinois, USA
|
Posted 4 Jul 2021 7:09 pm
|
|
I bought this guitar about a year ago or so and haven't played it much. it has been fine, but I'm now making some tuning changes. String 1 was originally tuned to rise from F# to G. Now I want it to go up a whole step. That's where the problem was discovered. Also string 10 was originally tuned to go down B to A. Now trying to tune it to Bb causes the same problem. _________________ Zum Encore, Zum Stage One, Fender 2000, Harlan Bros., Multi-Kord, |
|
|
|
Fred Glave
From: McHenry, Illinois, USA
|
Posted 6 Jul 2021 7:59 am
|
|
Thanks Jon Light, I believe your sticky provides the answers to my questions! _________________ Zum Encore, Zum Stage One, Fender 2000, Harlan Bros., Multi-Kord, |
|
|
|