Dunlop Hot Potz II

Jeremy Threlfall · From: now in Western Australia

i need to replace the pot in one of my (EB) volume pedals. the last time i did this was 5-6 years ago, when i fitted one of round normal-looking Hot Potz. Now there are these Hot Potz II flat-looking things, that come in 470k units. is this what people are fitting to their VPs in 2021?

https://www.amplifiedparts.com/products/potentiometer-dunlop-hot-potz-470-k
_________________
Luke Drifter on Facebook
https://www.facebook.com/ralwaybell
https://www.facebook.com/jeremy.j.threlfall
http://ralwaybell.bandcamp.com/

Jim Palenscar · From: Oceanside, Calif, USA

They're fine

Jerry Overstreet · From: Louisville Ky

Yeah, I've installed a few of these. Good to see they've revamped the contacts position.

You'll have to remove a circlip and pull the gear off and the shaft has a flat side where the set screw of the string barrel must go. Therefore, not much tweaking of the stop/start position. Otherwise, they work just fine.

Jeremy Threlfall · From: now in Western Australia

thank you fellows
_________________
Luke Drifter on Facebook
https://www.facebook.com/ralwaybell
https://www.facebook.com/jeremy.j.threlfall
http://ralwaybell.bandcamp.com/

Jeremy Threlfall · From: now in Western Australia

thank you fellows
_________________
Luke Drifter on Facebook
https://www.facebook.com/ralwaybell
https://www.facebook.com/jeremy.j.threlfall
http://ralwaybell.bandcamp.com/

Mike Bacciarini · From: Arizona

I use the Tom Bradshaw pot in my EB pedal. Very happy with it.
https://www.songwriter.com/bradshaw/potentiometers.php
_________________
MCI Arlington S-10 3+5, George L E-66, BJS & Emmons bars, Fender Stage Lead II 100W 1x12, Fender Satellite SFX, custom FX rack, 1983 Dobro 60D, Martin D16GT, Ibanez AS73, 1978 Rickenbacker 4000 custom.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: