| Author |
Topic: Pickup Question |
Bill Groner
From:
QUAKERTOWN, PA
|
Posted 17 Jan 2021 2:39 pm |
|
I am looking to buy a Lollar String Through Pup. When I went to order it, it asked you to specify single conductor or 4 conductor. Can anyone explain what this means? I bought one 3 years ago and I don't think there was an option like that?
Thanks in advance for some info.
_________________
Currently own, 6 Groner-tone lap steels, one 1953 Alamo Lap steel, Roland Cube, Fender Champion 40 |
|
|
 |
Steve Lipsey
From:
Portland, Oregon, USA
|
Posted 17 Jan 2021 2:59 pm
|
|
Hmmm...on a string-through it isn't obvious, like it is on a humbucker...but I've had very good luck going back to the source - they respond quickly and completely...
info@lollarguitars.com
_________________
https://www.lostsailorspdx.com
Williams S10s, Milkman Pedal Steel Mini & "The Amp"
Ben Bonham Resos, 1954 Oahu Diana, 1936 Oahu Parlor |
|
|
|
Bob Carlucci
From:
Candor, New York, USA
|
Posted 17 Jan 2021 3:01 pm
|
|
typically a 4 conductor allows additional tonal options, coil tap, etc,,, I would go this route as it makes any guitar more flexible..
The purpose of having the four coil leads available to the end user is so that you can wire the pickup with custom switching to get several different tones from one pickup.
Single coil pickups may also have multiple leads, called "taps." By utilizing the coil tap leads and some custom switching, you can reduce the impedance of the pickup by bypassing some of the coil windings, for a cleaner or brighter tone. Again, it's to get more than one tone from a single pickup.
_________________
I'm over the hill and hittin'rocks on the way down!
no gear list for me.. you don't have the time...... |
|
|
|
