| Author |
Topic: Clearwater pickup wiring |
Bruce Hogg
From:
United Kingdom
|
Posted 16 Jul 2020 7:17 am |
|
Can anyone provide me with a wiring diagram for a Clearwater lap steel (2 P90 style pups, 2 tone 1 volume pot)?
Rear pup is almost inaudible, and tone control is "odd" shall we say. Maybe bad solder joints but I'd like to know how it should be wired, in case the previous owner has tried to "mod" it!
Thanks |
|
|
 |
Jeff Highland
From:
New South Wales, Australia
|
Posted 16 Jul 2020 7:09 pm
|
|
If it's this one
https://www.amazon.co.uk/NEW-CLEARWATER-PRO-LAP-STEEL/dp/B001KPDZBA
It looks like it should be two volumes, a switch and a tone control.
If this is the case then the pickup hots should go to the most clockwise pot lugs (from underneath) the middle lugs on the volume pots would go to the switch and the output of the switch to the output jack and a separate wire to the tone pot.
_________________
Duesenberg Fairytale
1949 Supro Supreme
1950 National New Yorker
2008 Highland Baritone Weissenborn
2020 Highland New Yorker.
2020 Highland Mohan Veena
2021 Highland Weissencone |
|
|
|
Bruce Hogg
From:
United Kingdom
|
Posted 24 Jul 2020 11:46 am
|
|
| That is the wiring I had suspected, though it has two knobs marked "tone" and one marked "volume". However, I did find the fault. One support leg of the 3 way switch had snapped, allowing the switch body to move, and preventing proper switching. I managed a repair, and now all seems fine. |
|
|
|
