Wiring a new pickup

Paul Pearson · From: Alabama, USA

I have just bought a new Bill Lawrence 710 pickup it has 3 wires red,black and white how do I wire it up
Thanks for your info.

Dean Smith · From: DFW, Texas, USA

Not sure this will help since it is unclear if you are dealing with a D-10 or single neck. This was a drawing I used when replacing a simple on-off-on switch on my Mullen.

https://bb.steelguitarforum.com/viewtopic.php?t=344066&highlight=
_________________
Patrick "Dean" Smith

Richard Sinkler · From: aka: Rusty Strings -- Missoula, Montana

On Bill Lawrence pickups, the black wire is ground, white is hot, and red is used if you want to split the coils to have either a humbucker or single coil pickup. The red wire will go to a spst switch and then to ground. In one position, the pickup is single coil, in the other position of the switch, it is a hum humbucking pickup.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 55 years and still counting.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: