Ten-string lap-steel bridge

Tony Boadle · From: Skibbereen, County Cork, Ireland

Does anyone out there have a bridge for my ten-string lap-steel project? Anything considered, but I've seen some with a pick-up cut-out, similar to a changer design. That would be preferable! Thanks in advance....

Erv Niehaus · From: Litchfield, MN, USA

You could always just use a piece of stainless steel rod.
Erv

G Strout · From: Carabelle, Florida

Tony,
I may have what you need. There are two around here somewhere in the shop. Let me go through some boxes this afternoon / evening and i will PM you.
Gary
_________________
Melbert 8, Remington S8, Silk 6 string, Rick B6, Tremblay 6 lap steel, Marlen S-10 4&4, Prestige Guild M75 and Artist Award, Benedetto Bravo, Epiphone Century Electar (the real one) and a bunch of old lap steels.... mostly Ricks and Magnatones'

Tony Boadle · From: Skibbereen, County Cork, Ireland

Thanks Gary, let me know.

And thanks Erv, good idea but I'd prefer a pro bridge for this particular project. Suggested string gauges for a ten-string E6TH option would be appreciated if you have a moment though!

Jack Hanson · From: San Luis Valley, USA

Tony, please check you PMs regarding a bridge.

A good starting point to determine string gauges is John Ely's String Gauge Chart:

http://www.hawaiiansteel.com/graphics/pdf/string_gauge_chart.pdf

Good luck with your project!

Forum Index > Wanted To Buy		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: