| Author |
Topic: Dd3 With Your Amps Reverb. |
Wayne Quinn
From:
Cape Breton.NovaScotia
|
Posted 13 Jun 2019 8:47 am |
|
When using your DD3 delay should you turn your reverb on your amp off all the way or leave it at 3or 4 or higher. just wondering if I am the only one that leaves his on all the time.
_________________
D10 Carter, SD10 Mullen .Nashville 400,. peavey 112 Boss DD3., RV5, |
|
|
 |
Jerry Overstreet
From:
Louisville Ky
|
Posted 13 Jun 2019 9:45 am
|
|
| I can think of only a couple scenarios where I might not use reverb with delay on steel. 99.9% of the time, reverb is always on with or without delay at the settings you listed. |
|
|
|
Greg Lambert
From:
Illinois, USA
|
Posted 13 Jun 2019 10:37 am
|
|
| I set my reverb on 2 when using the DD3. |
|
|
|
Erv Niehaus
From:
Litchfield, MN, USA
|
Posted 13 Jun 2019 10:42 am
|
|
I just leave my amp's reverb at its normal setting when I add the DD3 delay. I place the delay last in line, just ahead of the amp. 
Erv |
|
|
|
Tommy Shown
From:
Denham Springs, La.
|
Posted 16 Jun 2019 12:06 pm
|
|
I run mine through the pre eq. patch on Nashvile. It does well.
Tommy Shown. |
|
|
|
Greg Lambert
From:
Illinois, USA
|
Posted 16 Jun 2019 12:22 pm
|
|
| Tommy Shown wrote: |
I run mine through the pre eq. patch on Nashvile. It does well.
Tommy Shown. |
Best place for it , so do I. |
|
|
|
