| Author |
Topic: Zum Parts (close it up, found my parts) |
David Decker
From:
Canton, Ohio, USA
|
Posted 19 Jan 2019 7:49 am |
|
Needing 3 Zum bell cranks like the ones in the picture. Also changer rods to fit with these bell cranks. Need 1 rod about 7 or 8 inches. 2 about 14" or abouts there. I can cut and shorten and rethread them where needed.
Last edited by David Decker on 24 Jan 2019 3:17 pm; edited 1 time in total |
|
|
 |
Tim Mathews
From:
Missouri, USA
|
Posted 21 Jan 2019 6:32 am
|
|
Call Bruce Zumsteg (816) 380-4568.
He can send the precut rods and bell cranks complete with tuning nuts |
|
|
|
Paddy Long
From:
Christchurch, New Zealand
|
Posted 21 Jan 2019 3:21 pm
|
|
I don't think Bruce has had those older comb type bell cranks for several years.
The newer side-attach variety will fit any of the older Zums though.
_________________
14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases. |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 22 Jan 2019 1:39 pm
|
|
David, I have these three only bellcranks and I make the rods for them with the 1/16†roll pin in the bellcrank end. I would make them slightly longer and you could cut to size and thread them. I have some nylon tuners but not sure they would be right length.
Please email me at rollermusic@cox.net if you would like my help.
Thanks, Jerry
_________________
http://www.littleoprey.org/ |
|
|
|
