Pilot light for a session 400 amp?

Jack Goodson · From: new brockton,alabama (deceased)

Doe,s anyone know of a quick source other than peavey that I could find the pilot light for a session 400 amp? It just connects with two wires so maybe I can install it....thanks jack

Paul Wade · From: mundelein,ill

jack,
try this place.
http://www.amprepairparts.com/jewels.htm

p.w

Jack Goodson · From: new brockton,alabama (deceased)

Paul, thanks for the info, I could not find the type that the session 400 uses. Maybe I did. Not Look in the right section. I know some of those would work but I would like to keep it original if possible....thanks jack

Paul Wade · From: mundelein,ill

jack,
best bet is to call peavey for the light

p.w

Jack Goodson · From: new brockton,alabama (deceased)

Thanks again Paul, I think I will go ahead and send the chassis to peavey and let them go thru it. I don,t know if you have tried a session 400 with the eps15c 4 ohm speaker, but it is killer tone....thanks jack

Paul Wade · From: mundelein,ill

jack, no have not tried it with that speaker. i have a session 400 with a peavey 1502 speaker. have not played
thru it for about 4 years to heavey to load around Smile

i used a evans fet 500 small cabinet

p.w

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: