| Author |
Topic: Allen Wrench sizes for Zum? |
Billy Murdoch
From:
Glasgow, Scotland, U.K.
|
Posted 7 Sep 2005 6:43 am |
|
I have a recently acquired Zum D10 and the Allen wrench sizes are confusing me.
I have one set imperial and one set metric and none of them fit.
I would have expected imperial since they are measured "across the flats"the sizes sold here are 1/8",5/32",3/16" and so on.
I would think the sizes I need are in 1/64"increments.
can anyone give me exact sizes and I will get down to a high class tool store.
Thanks in advance.
Best regards
Billy |
|
|
 |
Earnest Bovine
From:
Los Angeles CA USA
|
Posted 7 Sep 2005 8:17 am
|
|
Using three pairs of glasses and the old electron microscope I came up with these Zum allen wrench sizes:
9/64 hold knee lever on its support
7/64 hold knee levers on cross shafts, adjust knee lever position; limit the backward rotation (slack or slop) of cross shafts for pedals (not knee levers)
3/32 hold rod pullers onto cross shafts
5/64 hold the ends of the push rods of knee levers that push to the right |
|
|
|
Mike Sweeney
From:
Nashville,TN,USA
|
Posted 7 Sep 2005 8:47 am
|
|
| it takes a 7/64 wrench for the primary lower [split tuning] screws. |
|
|
|
Billy Murdoch
From:
Glasgow, Scotland, U.K.
|
Posted 7 Sep 2005 9:19 am
|
|
Thank you Earnest and Mike for your invaluable help,can you perhaps now tell me how to play like John Hughey?.Best regards
Billy |
|
|
|
Paul Norman
From:
Washington, North Carolina, USA
|
Posted 7 Sep 2005 4:26 pm
|
|
I can tell you. Buy all of his CDS DVds
you can get or afford and study day and night till you sound just like him. |
|
|
|
David Doggett
From:
Bawl'mer, MD (formerly of MS, Nawluns, Gnashville, Knocksville, Lost Angeles, Bahsten. and Philly)
|
Posted 7 Sep 2005 6:14 pm
|
|
| I just get a handful of different allen wrenches in front of me and keep trying them until one fits. Even if I knew the correct size, I can't read those little tiny numbers on those little black wrenches. |
|
|
|
