Thanks for the help all.. **Please Close**

Jerry Roller · From: Van Buren, Arkansas USA

What type wire do I need to hook up reverb tank in Peavey amp? Does it need to be shielded?
Thanks,
Jerry
_________________
http://www.littleoprey.org/

Pat Moore · From: Virginia USA

Hi Jerry,
I'm no schematic-head, but I would think it should be shielded.
If you google

Peavey reverb tank wiring

there's lots of pics. Couldn't upload it.
Hope this helps, Pat

Randy Owens · From: West Central Indiana, USA

I used a set of these: https://www.amazon.com/gp/product/B00DI89I04/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1 in my Session 400. They fit well and cured my intermittent reverb issue.

I'd guess that video cables with RCA jacks would do just as well.
_________________
2003 Mullen Royal Precision, Walker Stereo Steel, Ampeg G-15, Telonics FP-100

Mike Wheeler · From: Delaware, Ohio, USA

Jerry, Yes it has to be shielded. You only need a 4 foot long RCA, male to male cable...the regular gray hook-up cables are quite adequate. Cut it in half and use one end for the reverb input, and the other for the reverb output.

I'd suggest marking the cables to tell them apart.
_________________
Best regards,
Mike

Ken Fox · From: Nashville GA USA

This might be helpful

Jerry Roller · From: Van Buren, Arkansas USA

Thank you all so much!
Jerry
_________________
http://www.littleoprey.org/

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: