Farris,
I had a steel one time where the pedal board used the screws going through the legs, and was held on by wingnuts. Instead of having to remove & put on the wingnuts everytime, an earlier owner simply cut the inner part of the legs so that only about 3 inches or so were left, and you simply loosened the clutch and slipped the pedal bar, with short pieces of legs attached, down into the front legs and tightened the clutch. This made is super easy and fast to set up the guitar, and didn't hurt the sound of it in any way. Removal was a breeze too, as all you did was loosen the clutch, slip out the two short pieces still attached to the pedal bar, and drop it in the case.
Also, the pedal rack still fit in the case with absolutely no problem.
Lem[This message was edited by Lem Smith on 01 February 2005 at 08:45 PM.]
