| Author |
Topic: MPX 100 Lights out! |
Jack Willis
From:
California, USA
|
Posted 4 Apr 2016 1:52 pm |
|
My MPX 100 quit working as no signs of life. I am wondering if there is some power supply protection on the inside that can be reset or replaced? Any ideas would be appreciated.
_________________
Mullen SD10 pre RP, Milkman 40w mini steel, Wet reverb mono, Profex II, Yamaha keyboard, lots of books about music theory and PSG. |
|
|
 |
Mike Wheeler
From:
Delaware, Ohio, USA
|
Posted 5 Apr 2016 5:53 am
|
|
Have you tried another wall wart? Or, have you tested the current one to see if it still puts out 9VAC?
_________________
Best regards,
Mike |
|
|
|
David Nugent
From:
Gum Spring, Va.
|
Posted 5 Apr 2016 7:35 am
|
|
| May be equipped with an internal fuse which will necessitate removing the cover from the case. Be certain to replace it with one of the same value. |
|
|
|
Jack Willis
From:
California, USA
|
Posted 6 Apr 2016 4:44 pm
|
|
Wall wart is good. Next step check for fuse. Thanks fellas.
_________________
Mullen SD10 pre RP, Milkman 40w mini steel, Wet reverb mono, Profex II, Yamaha keyboard, lots of books about music theory and PSG. |
|
|
|
Jack Willis
From:
California, USA
|
Posted 6 Apr 2016 4:44 pm
|
|
Wall wart is good. Next step check for fuse. Thanks fellas.
_________________
Mullen SD10 pre RP, Milkman 40w mini steel, Wet reverb mono, Profex II, Yamaha keyboard, lots of books about music theory and PSG. |
|
|
|
