rodger_mcbride
From:
Minnesota
|
Posted 21 Mar 2016 8:35 am |
|
The PM55 is designed for performers who need to monitor their own signal, such as their vocals, with the main mix.
• XLR Mic In & Pass Through
• Ground lift on XLR signal
• Stereo/Mono 1/4" Monitor Input
• Headphone and earphone outputs • Battery or AC operation (AC Adaptor included)
• Lots of output level, it's loud.
DESCRIPTION
MIC THRU: XLR jack paralleled (hard-wired) to the MIC INPUT jack for pass-through to a mixer or other input device.
lift/gnd: Header jumper for con- necting or disconnecting the XLR ground (pin 1) to cassis ground. The PM55 is configured at the factory with pin 1 connected to ground.
MIC INPUT: XLR balanced jack
for connection to a condenser or
dynamic microphone.
MONITOR INPUT: 1/4" TRS
stereo jack for connection to a line source such as a mixer monitor/ auxiliary output, cassette player output, CD player output etc. POWER: This button turns the PM55 on and off.
BATTERY: Compartment for 9 Volt (alkaline preferred) battery. stereo/mono: Header jumper to configure the Monitor input for TRS stereo or TS mono operation. The PM55 is configured at the factory in stereo mode.
9 - 15 VDC: For connection to the Rolls PS27 AC power adapter. PHONE OUTPUTS: One 1/4" TRS stereo headphone output, one 1/8" TRS stereo earphone output.
pwr: Indicates the PM55 is on.
MIC LEVEL: Adjusts the level of signal coming from the MIC IN- PUT.
MONITOR LEVEL: Adjusts the level of the incoming signal from the Monitor Input.
PayPal preferred
Last edited by rodger_mcbride on 25 Mar 2016 7:15 am; edited 3 times in total |
|
