| Author |
Topic: New Cling on Tuner wrench |
Bob Cox
From:
Buckeye State
|
Posted 4 Nov 2015 4:45 pm |
|
Tune your guitar and snap this handy tuner to your guitar legg. Snap made of high quality pvc fastened with machine screw It will always be there, and handy when you need it. Only 12.50 free shiping. Two at 22.50 shipped Pay pal at rmce9@yahoo.com
Last edited by Bob Cox on 6 Nov 2015 6:44 pm; edited 1 time in total |
|
|
 |
James Jacoby
From:
Ohio, USA
|
Posted 6 Nov 2015 10:00 am
|
|
| Does the knurled knob, come off the clip, or do you just remove the whole thing, and use it like that? -Jake- |
|
|
|
James Jacoby
From:
Ohio, USA
|
Posted 6 Nov 2015 10:02 am
|
|
| Will you have some to sell, at the jam? -Jake- |
|
|
|
Bob Cox
From:
Buckeye State
|
Posted 6 Nov 2015 6:41 pm
|
|
it is fastened with drilled machine screw use the whole wrench, the added width makes it better too.
I will have some at the jam |
|
|
|
James Jacoby
From:
Ohio, USA
|
Posted 30 Nov 2015 11:24 pm
|
|
One of the best ideas I've seen in a long time! And if you DO lay em down, on your steel, or table,etc., they won't roll off, plus the added leverage from the clip, makes it easier to smoothly turn those stubborn plastic tuning nuts! One thing, though! You guys with Sierras will have to have to buy flashlights, to find your old type, round ones  -Jake- |
|
|
|
James Jacoby
From:
Ohio, USA
|
Posted 30 Nov 2015 11:36 pm
|
|
Sorry about the typo! What happened was, I went into my music room to take one of mine, and make sure they wouldn't roll off a flat surface, and when I came back, I repeated a couple words. I should have proof read, before I clicked on the submit button  |
|
|
|
