| Author |
Topic: Wiring diagram for speaker volume control |
Marty Nemanick
From:
Madera, California, USA
|
Posted 15 Aug 2015 11:22 am |
|
I want to install an L pad on an extension speaker and I am not sure how to connect the three posts on the pot to the input jack and the speaker. Could one of you folks explain how to do this, I would greatly appreciate it.
Thank you,
Marty |
|
|
 |
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 15 Aug 2015 11:41 am
|
|
If you google 'l-pad wiring' you'll find the image you need.
Basically, put the amp into 1 & 3, and take the speaker off of 1 & 2. Choose the rotation direction you want... most folks choose clockwise = louder, so you'd make it so terminal 3 is closest to the end where the wiper ends up. Terminal 2 is the center one, obviously.
_________________
New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329 |
|
|
|
Marty Nemanick
From:
Madera, California, USA
|
Posted 15 Aug 2015 5:39 pm
|
|
| Thank you Stephen, should have thought of that myself. |
|
|
|
ajm
From:
Los Angeles
|
Posted 19 Aug 2015 6:38 am
|
|
Stop.
What kind of amp? Tube or SS?
No offense meant, but if you don't really understand what you are doing you could seriously "hurt" the amp, or attenuator, or both. |
|
|
|
