| Author |
Topic: Question on Dunlop 470K pot CLOSE / ANSWERED |
Scott Duckworth
From:
Etowah, TN Western Foothills of the Smokies
|
Posted 23 May 2015 10:24 am |
|
I need this dimension of a Dunlop 470K pot...
Or if someone can point me to a mechanical drawing of those pots. Most manufacturers have them, but I can't find one on the Dunlop.
Also, do the Dunlop pots fit into the Ernie Ball VPjr without redrilling the mounting block?
Thanks in advance for the info.
_________________
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it
I may, in fact, be nuts. However, I am screwed onto the right bolt... Jesus!
Last edited by Scott Duckworth on 25 May 2015 8:22 am; edited 1 time in total |
|
|
 |
John Billings
From:
Ohio, USA
|
Posted 23 May 2015 2:33 pm
|
|
Ya know Scott,,,, just as an aside, I was looking for a replacement pot several years ago, and found that Dunlop pot. Think it's for a Wah pedal. I asked here on the Forum if it would be a suitable replacement for the 500K AB pot. EVERYBODY told me "No!"
_________________
Dr. Z Surgical Steel amp, amazing!
"74 Bud S-10 3&6
'73 Bud S-10 3&5(under construction)
'63 Fingertip S-10, at James awaiting 6 knees
'57 Strat, LP Blue
'91 Tele with 60's Maple neck
Dozen more guitars!
Dozens of amps, but SF Quad reverb, Rick Johnson cabs. JBL 15, '64 Vibroverb for at home.
'52 and '56 Pro Amps |
|
|
|
Scott Duckworth
From:
Etowah, TN Western Foothills of the Smokies
|
|
|
|
Mike Schwartzman
From:
Maryland, USA
|
Posted 23 May 2015 6:04 pm
|
|
Got it Scott...my ruler says that measures 5/8ths of an inch.
_________________
Emmons Push Pull, BMI, Session 400, Home of the Slimcaster Tele. |
|
|
|
Brad Sarno
From:
St. Louis, MO USA
|
|
|
|
Scott Duckworth
From:
Etowah, TN Western Foothills of the Smokies
|
Posted 25 May 2015 8:22 am
|
|
Thanks Mike!
_________________
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it
I may, in fact, be nuts. However, I am screwed onto the right bolt... Jesus! |
|
|
|
