| Visit Our Catalog at SteelGuitarShopper.com |

Post new topic change pulls on carter starter?
Reply to topic
Author Topic:  change pulls on carter starter?
Brooker Buckingham

 

From:
Calgary, Alberta, Canada
Post  Posted 29 Aug 2002 1:55 pm    
Reply with quote

Is it possible to change the pulls on the Carter Starter? I'd like to try out Jimmy Day's set up that b0b has in the tunings section on his website:
http://www.b0b.com/tunings/stars.html#E9jd

I'm pretty sure Al Brisco said he could do it when he sold it to me, but he recommended I try out the standard tuning.
View user's profile Send private message Send e-mail
Jeff Peterson

 

From:
Nashville, TN USA
Post  Posted 29 Aug 2002 4:31 pm    
Reply with quote

Again, keep the Carter original. They are cheap enough/real hard to modify. Sell or trade for another guitar that is easily changed. The Carter was made as a starter with a more or less 'permanent' set up....that's it. What value it has, is in it's original condition.
View user's profile Send private message Visit poster's website
richard burton


From:
Britain
Post  Posted 30 Aug 2002 11:56 am    
Reply with quote

A quick method to try out the Day set-up, to see if it is suitable for you, is to back off the nylon tuning nut on the 4th string (the one that is attached to the 'C' pedal). Now, the 'C' pedal can simulate the 'A' pedal, so you can try out the Day pedal configuration and see if you like it. You will have to forget the left knee levers, though, while you do this test.
View user's profile Send private message Send e-mail
Richard Sinkler


From:
aka: Rusty Strings -- Missoula, Montana
Post  Posted 30 Aug 2002 2:05 pm    
Reply with quote

Great suggestion Richard (nice name too ). I have played the "Day" setup for about 30 years now, and played the "Emmons" setup for a year prior to that until a friend talked me into switching. I can say I prefer the Day setup and have my reasons, which I won't go into because that's not what this topic is about. I say leave it as it is and learn the Emmons setup. You can't go wrong with either setup, as has been proven by scores of players on both sides.


------------------
Carter D10 9p/10k
Richard Sinkler

View user's profile Send private message Send e-mail
DroopyPawn

 

From:
Fox, OK, USA
Post  Posted 20 Nov 2003 7:56 pm    
Reply with quote

This has been asked before, but how hard is it to change the copedent on a Carter Starter?

------------------

View user's profile Send private message Send e-mail Visit poster's website
Jerry Roller


From:
Van Buren, Arkansas USA
Post  Posted 20 Nov 2003 8:32 pm    
Reply with quote

Brooker, if you are relatively new at the pedal steel I would strongly recommend that you stick with the Emmons set-up. I have played the Day set-up for 42 or so years but I think any new player would be wise to stay with Emmons. Most guitars are set up that way and I don't know of a good reason to go the other way. I play the way I learned. If there are any good reasons for changing there are as many good reasons not to.
Jerry
View user's profile Send private message Visit poster's website
Mark van Allen


From:
Watkinsville, Ga. USA
Post  Posted 21 Nov 2003 10:17 am    
Reply with quote

Brooker, I'd agree with Jerry on this, 95% or more of the time you're around other steelers, checking out new guitars at a show, etc. they're Emmons setup, and it sure is hard to swap out once you're "trained". I switched back and forth with little trouble over the first few years I was playing, then settled into the Emmons setup. Then after falling off a 3 story roof and dislocating my ankle, I found as it healed it turned more easily in the "Day" direction and I began playing that way again. I recently got a guitar with the Emmons setup and put in a lot of time on it, hoping to switch back for the 95% reason- but I've just become too entrenched in the Day setup. There are just too many musical phrases in my body that won't change direction! I think there are a few "moves" that may be slightly easier on one setup or the other, but basically, there's no musical difference, so it would seem advantageous to stick with the setup you'll run into more often.

------------------
Stop by the Steel Store at: www.markvanallen.com
View user's profile Send private message Send e-mail Visit poster's website
DroopyPawn

 

From:
Fox, OK, USA
Post  Posted 21 Nov 2003 11:36 am    
Reply with quote

My ankles have a lot of trouble "folding up" in the Emmons set up. I tried it. Day is the way, for me I say.

I would not Emmons in a hat,
I would not Emmons with a cat.
I would not Emmons in a box,
I would not Emmons with a fox......


------------------

View user's profile Send private message Send e-mail Visit poster's website
Al Marcus


From:
Cedar Springs,MI USA (deceased)
Post  Posted 21 Nov 2003 3:56 pm    
Reply with quote

I found that physiologicly, the Day setup is easier to bend the ankle IN instead of the Emmons out.

I have played it both ways and gave plenty of time for each.

For me the Day setup is faster and more comfortable.

But pay attention to what Jerry and Mark said. Most everything is geared to the Emmons setup.

After saying all that about me liking the Day setup, I am playing the Emmons setup!

Because that is what is what is on most guitars.................al

------------------
My Website..... www.cmedic.net/~almarcus/

View user's profile Send private message Visit poster's website

All times are GMT - 8 Hours
Jump to:  
Please review our Forum Rules and Policies
Our Online Catalog
Strings, CDs, instruction, and steel guitar accessories
www.SteelGuitarShopper.com

The Steel Guitar Forum
148 S. Cloverdale Blvd.
Cloverdale, CA 95425 USA

Click Here to Send a Donation

Email SteelGuitarForum@gmail.com for technical support.


BIAB Styles
Ray Price Shuffles for Band-in-a-Box
by Jim Baron