| Author |
Topic: "e clips" for Emmons LeGrand rods |
Jim Bates
From:
Alvin, Texas, USA
|
Posted 12 Oct 2014 9:05 am |
|
I need a couple of the e-clips that fit the Emmons LeGrand
rods. Local hardware did not have the right size, either too big or too small.
Anyone have a couple I could buy?
Thanx,
Jim Bates |
|
|
 |
Joe Naylor
From:
Avondale, Arizona, USA
|
Posted 12 Oct 2014 9:30 am Steel Guitar East
|
|
Check with Billy Knowles - Steel Guitars East
Joe Naylor
www.steelseat.com
_________________
Joe Naylor, Avondale, AZ (Phoenix) Announcer/Emcee owner www.steelseat.com *** OFFERING SEATS AND Effects cases with or without legs and other stuff ****** -Desert Rose Guitar S-10, Life Member of the Arizona Carport Pickers Assoc., Southwest Steel Guitar Assoc., Texas Steel Guitar Assoc., GA Steel Guitar Assoc., KS Steel Guitar Assoc. (Asleep at the Steel) tag line willed to me by a close late friend RIP |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
|
|
|
Jim Bates
From:
Alvin, Texas, USA
|
Posted 13 Oct 2014 4:47 pm
|
|
Found some. Thanks for your help.
Jim |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 13 Oct 2014 5:21 pm
|
|
Jim, did you email me your mailing address or did you find some somewhere else?
Thanks,
Jerry
_________________
http://www.littleoprey.org/ |
|
|
|
Fred Layman
From:
Springfield, Missouri USA
|
Posted 14 Oct 2014 11:47 am wire clip
|
|
| If you will go to the "Steel Guitar Builders" site on page 1 or 2 there are directions on how to make a spring pedal clip (that holds the pull rod in place in the bell crank) These were used in many steels in an earlier time and were dependable for retaining the pull rod in place. |
|
|
|
Fred Layman
From:
Springfield, Missouri USA
|
Posted 14 Oct 2014 11:49 am wire clip
|
|
| If you will go to the "Steel Guitar Builders" site on page 1 or 2 there are directions on how to make a spring pedal clip (that holds the pull rod in place in the bell crank) These were used in several steels in an earlier time and were dependable for retaining the pull rod in place. |
|
|
|
Larry Henson
From:
Texas, USA
|
Posted 14 Oct 2014 2:50 pm
|
|
Jerry,
I sent you a couple of emails ref parts...haven't heard back from you.....you're probably like me ...check emails every week or so. No big deal, just let me know when you get time.
Thanks, Larry |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 14 Oct 2014 3:03 pm
|
|
Larry H. I did answer your email. It appears Jim no longer needs my help.
Jerry
_________________
http://www.littleoprey.org/ |
|
|
|
