| Author |
Topic: What size pedal rods |
Jimmy Gibson
From:
Cornwall, England
|
Posted 24 Jun 2014 5:33 am |
|
Could someone please give me the diameter size of the pedal rods that Sho-Bud Pro 2 Custom use..
Thanks Jimmy. |
|
|
 |
Martin Weenick
From:
Lecanto, FL, USA
|
Posted 24 Jun 2014 7:26 am Pedal Rods
|
|
Most all pedal rods are 3/16. I have seen a very few that were 11/64,but only once or twice. Most all Sho Bud pull rods are .109 or 7/64. Martin.
_________________
Several custom steels. NV-112 Boss DD-7 |
|
|
|
Michael Yahl
From:
Troy, Texas!
|
Posted 24 Jun 2014 8:12 am
|
|
If your undercarriage is built with the 5/16" hex cross shafts, then your pedal rods will be Ø.106-.109" with a #10-32 rolled thread. That is the configuration that Sho~Bud went to when they introduced the diecast components. The top of the rod will also have an "apron" bend to keep it from possibly rubbing the inside of the front apron.
If it has round cross shafts and 2 hole pulls, then the pedal rod will be a straight Ø.187" rod with a cut #10-32 thread.
Hope this helps.
_________________
"Don't fergit to kiss yer horse!"
'72 Sho-Bud Professional D10, (in pieces .....), '78 MSA Classic XL D10, '69 Emmons PP, Fender 2000
Peavey Session 500 BW, Crate Digital Modeling Amp
PSG PARTS
http://www.psgparts.com/ |
|
|
|
Ian Rae
From:
Redditch, England
|
Posted 24 Jun 2014 9:47 am
|
|
I make pedal rods from the nearest metric equivalent, which is 5 mm. It is a little fatter than 3/16" but will take a #10 x 32 thread once you get it started.
_________________
Make sleeping dogs tell the truth!
Homebuilt keyless U12 7x5, Excel keyless U12 8x8, Williams keyless U12 7x8, Telonics rack and 15" cabs |
|
|
|
