Steel Guitar Strings

Robert Herr · From: Willow Street,Pa

I am looking for some guidelines on what strings most steelers are using on their E-9 setup.

Bob Knight · From: Bowling Green KY

This should give you some guidelines.

http://b0b.com/products/strings.html

[This message was edited by Bob Knight on 04 October 2002 at 05:46 AM.]

David Mason · From: Cambridge, MD, USA

This chart (another of B0B's covers alternates for raises. http://www.b0b.com/infoedu/gauges.htm

Larry Bell · From: Englewood, Florida

Most players use packaged sets.
Go to Scotty's Music website and take a look at the string sets he sells. Those are pretty typical gauges. There's the 'Nashville' style set that tends to be a bit lighter than the 'Tension Balanced' set -- both for E9 and C6. There are also sets for 12-string E9/B6 -- or else you can buy strings separately -- individual strings or by the dozen (that's what I prefer).

Some players prefer nickel; others prefer stainless. It is noteworthy that ONLY THE WOUND STRINGS ARE DIFFERENT -- the plain ones are the same material. There are very few mfgrs of the string wire. Many companies wind their own -- but that's just for the wound. There are also a few different alloys available, such as the Cobra Coil that Bobbe Seymour sells at Steel Guitar Nashville

------------------
Larry Bell - email: larry@larrybell.org - gigs - Home Page
2000 Fessenden S-12 8x8, 1969 Emmons S-12 6x6, 1971 Dobro

John Knight · From: Alaska

Here is another source. They have been real good to me. http://www.juststrings.com/pedalsteelguitar.html

------------------
D 10 Thomas with 8&6, '61'D-10 Sho-Bud 8&4
S12 Knight 4&4
Nashville 400 and Profex II
81' Fender Twin JBL's
Asleep at the Steel

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: