| Author |
Topic: Carter Pull Rod Diameter and thread |
Jarek Anderson
From:
Ontario, Canada
|
Posted 12 Feb 2014 1:24 pm |
|
Good day everyone
I've done 2 days of coffee break searches on this forum, using the built in tool, and the google search... but I can't find the definitive answer for what diameter, and thread I need to add pulls to my Carter.
As of right now, I'm thinking that I need a 3/32 welding rod with a 4-40 die to put the thread on it.
Am I correct? Should I use a different diameter, material, or thread?
Thanks,
Jarek |
|
|
 |
Dick Wood
From:
Springtown Texas, USA
|
Posted 12 Feb 2014 1:39 pm
|
|
I believe John once told me due to the size of their rods,the threads were rolled.
_________________
Cops aren't paid much so I steel at night.
Last edited by Dick Wood on 12 Feb 2014 4:26 pm; edited 1 time in total |
|
|
|
Howard Montgomery
From:
Topeka, KS US
|
Posted 12 Feb 2014 2:08 pm
|
|
| That is what I used and they worked fine |
|
|
|
John Swain
From:
Winchester, Va
|
Posted 12 Feb 2014 2:58 pm
|
|
| 3/32 + 4/40 work fine. I went to welding supply outlet for stainless welding rods per John Fabian. They were priced at ten pounds for $60, I said I only needed four and they gave them to me! JS |
|
|
|
Jarek Anderson
From:
Ontario, Canada
|
Posted 12 Feb 2014 6:21 pm
|
|
| John Swain wrote: |
| 3/32 + 4/40 work fine. I went to welding supply outlet for stainless welding rods per John Fabian. They were priced at ten pounds for $60, I said I only needed four and they gave them to me! JS |
I should have gone with my instinct and sent you a PM John... I found your post from a couple years ago saying that... but without the sizes!
Thanks for your replies everyone! |
|
|
|
