Roger Francis
From:
kokomo,Indiana, USA
|
Posted 28 Jan 2014 12:26 pm |
|
I know this has been discussed before about how tight the neck should be tightened when you put it back on after a good cleaning but for you guys who refurb steels is there a general rule you go by when putting the neck back on? I have cleaned the screws and the holes in the neck and was planning on putting a little blue loc-tite on the screws, screw them in till the head of the screw gets seated and then just give them a light snug just to keep the neck in place. I would appriciate any feed back, thanks in advance, Roger
_________________
Rittenberry SD10, 2 nashville 112s with telonics speaker, behringer EPQ450 power amp, 705 pups, Telonics FP-100, live steel strings, mogami cords, wet reverb |
|
