| Author |
Topic: Problem Installing An Eminence EPS-15 In A Nashville 400 |
Jack Stanton
From:
Somewhere in the swamps of Jersey
|
Posted 5 Dec 2013 10:30 pm |
|
Went to put the Eminence into a recently acquired later model Nashville and darned if it would not fit. The bottom of the frame needs more space. I've put JBL's & Sica's in other Nashville's, no problem.
Anyone else ever encounter this?
Now where did I put those dang chisels?... |
|
|
 |
Chuck Blake
From:
West Virginia, USA
|
Posted 6 Dec 2013 7:21 am
|
|
Jack I use the EPS 15C in my 400 but I use split cabs. When you find the chisel you're gonna love the new speaker and it's weight.
Chuck
_________________
2010 Rains 3x5 SD10, 2006 Rains 3x5 SD10 Powered by Quilter Tone Block 202 and 15' and 12' Custom Speaker cabs |
|
|
|
Dick Sexton
From:
Greenville, Ohio
|
Posted 6 Dec 2013 12:11 pm Eminece in a 400...
|
|
| Jack, I've installed two, in separate NV400 "black corner" cabinets without a clearance problem. However, where I did have a problem, was in mounting the speakers. I found that the mounting bolts where to short. I ended up getting Hillman 10-32 X 9/32 Tee Nuts - Brad Hole Stainless "Blind Nuts". #883042 at my local Lowes. Added a nylon washer behind the blind nut and wala... |
|
|
|
Jack Stanton
From:
Somewhere in the swamps of Jersey
|
Posted 6 Dec 2013 12:40 pm
|
|
| Got it in, only needed to take a very small section of the cabinet bottom about a 1/16th of an inch. Haven't had time to play it yet, but I'm liking the weight difference! |
|
|
|
