| Author |
Topic: Vegas 400 Loud Hum Then Blows Fuse |
Mark Kuban
From:
Texas, USA
|
Posted 15 Aug 2014 1:59 pm |
|
| Bought a basically nonworking Vegas 400 for cheap off of craigslist. What it does is make a loud hum for 30 seconds or so and then it blows the power fuse. Any ideas where to start troubleshooting? |
|
|
 |
Lane Gray
From:
Topeka, KS
|
Posted 15 Aug 2014 2:22 pm
|
|
Anything that will pass enough current to blow a 6A fuse WILL be hot. I'd pull the chassis, give it a fresh fuse (what a shame they don't have circuit breakers in the AGC form), turn it on and wave your hand just above it after it blows again. The bit that feels hot is probably the culprit.
I'd also be inclined to look first for signs of heat damage, then at filter caps and maybe put an ohmmeter on the coils of the transformer.
Again, I'm not a tech, just a cat with some logic.
EDIT: That logic leads me to suspect something in the power supply rather than the preamp or power amp section. The amps run on lower voltages, so would need INSANE current draws to suck 6A of house current.
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Marvin Born
From:
Ohio, USA
|
Posted 15 Aug 2014 6:29 pm
|
|
| Check for a shorted output transistor or driver transistor. Then check ESR of the filter caps. |
|
|
|
Mark Kuban
From:
Texas, USA
|
Posted 16 Aug 2014 3:58 pm
|
|
Thanks! Will attempt to find those things mentioned. Not much experience working on solid state amps, just tube amps.
I if have too much trouble, I guess I'll take it to a tech. |
|
|
|
John Billings
From:
Ohio, USA
|
Posted 16 Aug 2014 5:01 pm
|
|
| Maybe get some Component Cooler, if you can find a Radio Shack that's still open. Handy stuff! Better than waving your hand around. Remove the chassis, spray the cooler, and turn it on. Anything overheating will show right away. At least I think that's the right method! I haven';t used my can in 20 years, so maybe someone else can comment on it's use? And if it's applicable in this case? I think it will show parts that have heat issues, but maybe not shorts or opens? |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 16 Aug 2014 5:19 pm
|
|
If it was an output shorted it should take the fuse out immediately no questions asked (and make less noise). You probably have a blown rectifier in your power supply, I'd start there... next would be filter caps.
_________________
New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329 |
|
|
|
