| Author |
Topic: Question for Roland 80xl usersPLEASE CLOSE THANKS |
billy tam R.I.P.
From:
baton rouge, louisiana
|
Posted 27 Jun 2013 3:55 am |
|
I bought a new Roland cube 80xl 3 or 4 weeks ago and have a couple of issues to ask about. I seem to have some distortion at times, it almost seems as if the input signal is too hot. Sho-Bud Super Pro totally restored. Also it seems to me that the delay tap is extraordinarily loud and hard to adjust. Any settings advice or other ideas would be appreciated.
Thanks,
Billy
Last edited by billy tam R.I.P. on 27 Jun 2013 1:39 pm; edited 1 time in total |
|
|
 |
Chuck Blake
From:
West Virginia, USA
|
Posted 27 Jun 2013 6:16 am
|
|
Billy regarding your questions.
The only tone issue is and i think in other post discussed. When striking 3 and 4 an overtone is heard. I describe it as piercing.
As far as delay tap, I never experienced that but mine seems to have only 2 speeds, fast and slow 
However I do enjoy the weight savings and when power is required I take two of them with me.
Chuck
_________________
2010 Rains 3x5 SD10, 2006 Rains 3x5 SD10 Powered by Quilter Tone Block 202 and 15' and 12' Custom Speaker cabs |
|
|
|
Ollin Landers
From:
Willow Springs, NC
|
Posted 27 Jun 2013 12:02 pm
|
|
From the manual
Setting the Delay Time for Short Delay
If you hold down the switch for one second or longer, the delay time will be set to 30 ms.
Each time you then press the [REC/PLAY/DUB]
switch, the delay time will change over four steps
(30 ms/50 ms/70ms/90 ms) to a maximum of 90 ms.
*The short delay cannot be set using the foot switch. |
|
|
|
billy tam R.I.P.
From:
baton rouge, louisiana
|
Posted 27 Jun 2013 1:38 pm roland
|
|
Thanks for the input guys. I was able to go to the dealer today and learned a few things about the unit.
Your input is appreciated.
Billy |
|
|
|
