| Author |
Topic: Tonealigner pickup |
David Nugent
From:
Gum Spring, Va.
|
Posted 6 Jun 2013 5:50 pm |
|
| Installed a used Tonealigner pickup today and have a problem; when the pickup is tapped the signal is audible through the amp but no response is heard when the strings are struck, suggestions? |
|
|
 |
Tim Marcus
From:
San Francisco, CA
|
Posted 6 Jun 2013 7:05 pm
|
|
can you test it with an ohm meter?
maybe you wired it wrong - does the pickup go straight to the 1/4" jack on your steel?
_________________
Milkmansound.com |
|
|
|
David Nugent
From:
Gum Spring, Va.
|
Posted 6 Jun 2013 7:41 pm
|
|
| Tim...Was wired correctly and directly to the jack. After removing the pickup I believe I may have discovered the problem. The ground wire appears to have pulled loose from the pickup housing. The wire and the solder that secured it came loose in one piece. Will contact the builder and make arrangements to have it repaired. Thank you for the reply. |
|
|
|
Bob Hoffnar
From:
Austin, Tx
|
Posted 6 Jun 2013 7:52 pm
|
|
David,
Give me a call and I'll take care of whatever the problem is.
Thanks, Bob 917 572 5416
_________________
Bob |
|
|
|
David Nugent
From:
Gum Spring, Va.
|
Posted 7 Jun 2013 3:12 am
|
|
| Bob...Thank you for the quick response. Will contact you today...Thanks again. |
|
|
|
