| Author |
Topic: need a plastic tuner button PLEASE CLOSE |
Ron Victoria
From:
New Jersey, USA
|
Posted 8 May 2013 4:25 pm |
|
I have a Goldtone and one of the plastic buttons cracked in half. I was wondering if anyone has a white or ivory one? It's held on to the shaft with a small (#4?) machine screw. I'm sure it doesn't have to to a Goldtone to fit.
thanks, Ron
Last edited by Ron Victoria on 9 May 2013 9:43 am; edited 1 time in total |
|
|
 |
Joe Naylor
From:
Avondale, Arizona, USA
|
Posted 8 May 2013 5:20 pm try this one
|
|
try stewmac.com if you do not find it call them and they do help you out
Joe Naylor
www.steelseat.com
_________________
Joe Naylor, Avondale, AZ (Phoenix) Announcer/Emcee owner www.steelseat.com *** OFFERING SEATS AND Effects cases with or without legs and other stuff ****** -Desert Rose Guitar S-10, Life Member of the Arizona Carport Pickers Assoc., Southwest Steel Guitar Assoc., Texas Steel Guitar Assoc., GA Steel Guitar Assoc., KS Steel Guitar Assoc. (Asleep at the Steel) tag line willed to me by a close late friend RIP |
|
|
|
Ron Victoria
From:
New Jersey, USA
|
Posted 8 May 2013 5:36 pm
|
|
I checked them first but they sell sets only. I intend to replace the machines over the next few months but just need a temporary fix to tune.
ron |
|
|
|
Michael Maddex
From:
Northern New Mexico, USA
|
Posted 8 May 2013 7:14 pm
|
|
Ron, Elderly usually has a selection of single buttons.
If it is a short term temp fix, slap a baby vise-grip on the shaft and you should be good to go. 
HTH.
_________________
"For every expert, there is an equal and opposite expert." -- Arthur C. Clarke |
|
|
|
Ron Victoria
From:
New Jersey, USA
|
Posted 9 May 2013 9:44 am
|
|
I purchased a new set of machines from Beard and will have them in a few days. I noticed the next button had a crack in it.
ron |
|
|
|
