| Author |
Topic: For Sale: JCH SD-10 Pedal Steel Guitar-SOLD !! |
Al Vesel
From:
Chisholm, Minnesota, USA
|
Posted 3 Nov 2012 10:52 pm |
|
For Sale: JCH Pedal Steel Guitar SD-10 3 pedal x 6 knee levers. Emmons Set up. Guitar is in great shape. This is not an SD-10 conversion. It is an original SD-10. There is a side plate installed where the C6 neck is, but I've had many guitars, including Emmons LeGrande's that have had this same scenario. They used the same end plates for SD-10's as D-10's.
Guitar has triple raise/triple lower all pull changer, square hex shafts, & 4 hole bell cranks.
Guitar has a George L E-66 pickup & Sperzel tuners at the keyhead.
The switch has been disconnected, but is enclosed. It was not on the guitar when I purchased it, but it is there with all of its hardware. When I received the guitar it was not installed. I just didn't put it back on. I don't know if it works or not. A lot of people that owned these JCH's with these types of push button switches took them off as they did have a tendency to go bad after a while. So you don't need it anyway. So the pickup is just wired direct to jack. Sounds great. The switch may or may not work. I just didn't want to install it & don't have the proper equipment to test it.
Copedent as follows:
Emmons set up
Pedal A raises strings 5 & 10
Pedal B raises strings 3 & 6
Pedal C raises strings 4 & 5
Left outer front knee lever raises the E's to F
Left outer rear knee lever lowers 5 & 10 a 1/2 tone
Left inner knee lever raises 1 & 7 a full tone
Left vertical knee lever lowers 3 & 6 a 1/2 tone
Right inner knee lever lowers the E's to D#
Right outer knee lever lowers 2 a full tone & 9 a 1/2 tone.
Guitar comes with original case and leg bag.
It sounds and plays like a dream.
Price: $2,325.00 (add $65.00 shipping lower fourty eight)
SORRY - NO TRADES - CASH ONLY.
Contact email: alvesel@mchsi.com or contact me thru the forum's email system or send a pm
Any questions contact me.
_________________
Emmons LeGrande SKH D-10 - WALKER STEREO STEEL AMP w JBL ENCLOSURES & TC ELECTRONICS M-ONE XL PROCESSOR, HILTON VP,FURMAN POWER CONDITIONER, SARNO's Steel Guitar BLACK BOX,BJS,ToneMaster bars,FENDER Strat, FENDER & Ovation acoustic's
Last edited by Al Vesel on 28 Nov 2012 8:27 am; edited 9 times in total |
|
|
 |
Ted Nesbitt
From:
Northern Ireland
|
Posted 4 Nov 2012 3:48 am Jch
|
|
| What a great deal ..... These guitars will increase in value just like Franklin steels. Wonderfull instruments. Built by a man who put his heart and soul into every guitar. Good luck with the sale Al |
|
|
|
Tony Dingus
From:
Kingsport, Tennessee, USA
|
Posted 4 Nov 2012 6:37 pm
|
|
This is a great guitar. Plays great and has a sweet tone. Stays in tune too.
Tony |
|
|
|
Scott Henderson
From:
Camdenton, Missouri, USA
|
Posted 5 Nov 2012 8:04 pm
|
|
Just curious what the serial number is....Looks just like a single neck version of my D-10
_________________
D-10 JCH Dekley U-12 D-8 Magnatone Mullen RP Evans RE 200 profex 2 BJS bars
Dentyne gum (peppermint) |
|
|
|
Brint Hannay
From:
Maryland, USA
|
Posted 9 Nov 2012 12:18 pm
|
|
| What are the controls seen in the picture? And is the switch you referred to something additional? |
|
|
|
Al Vesel
From:
Chisholm, Minnesota, USA
|
Posted 9 Nov 2012 12:56 pm JCH SD-10 3 x 6
|
|
Brint,
As I stated in the add, I do not have them hooked up now. They were for the tone control, and also if there was a coil tap pickup installed on the guitar. Also if you had a D-10, to switch the necks, from E9 to C6. I was told that Jimmy put them on all of his guitars, either SD-10's or D-10's. So the same control was used on all of his guitars. These are similar to what Emmons LeGrande's use, except these are push button.
You can try and hook them up if you purchase the guitar. They may work. You actually do not need them anyway.
TXS for the inquiry.
_________________
Emmons LeGrande SKH D-10 - WALKER STEREO STEEL AMP w JBL ENCLOSURES & TC ELECTRONICS M-ONE XL PROCESSOR, HILTON VP,FURMAN POWER CONDITIONER, SARNO's Steel Guitar BLACK BOX,BJS,ToneMaster bars,FENDER Strat, FENDER & Ovation acoustic's
Last edited by Al Vesel on 28 Nov 2012 5:30 am; edited 1 time in total |
|
|
|
Al Vesel
From:
Chisholm, Minnesota, USA
|
Posted 9 Nov 2012 1:03 pm JCH SD-10 3 x 6
|
|
Scott,
I know I sent you an email and told you what the serial number is. If anyone else would like to know, it is
#1061.
TXS
Al V. 
_________________
Emmons LeGrande SKH D-10 - WALKER STEREO STEEL AMP w JBL ENCLOSURES & TC ELECTRONICS M-ONE XL PROCESSOR, HILTON VP,FURMAN POWER CONDITIONER, SARNO's Steel Guitar BLACK BOX,BJS,ToneMaster bars,FENDER Strat, FENDER & Ovation acoustic's |
|
|
|
Al Vesel
From:
Chisholm, Minnesota, USA
|
Posted 13 Nov 2012 6:52 pm JCH SD-10 3 x 6 PRICE LOWERED !!!
|
|
I JUST LOWERED THE PRICE ON THE JCH-
GREAT BUY !! These will continue to go up in value and price.
Listen to Lloyd Green play his JCH on the Youtube link below. Awesome sounding guitars. Here it is:
http://www.youtube.com/watch?v=IbjViunwfvQ
Al
_________________
Emmons LeGrande SKH D-10 - WALKER STEREO STEEL AMP w JBL ENCLOSURES & TC ELECTRONICS M-ONE XL PROCESSOR, HILTON VP,FURMAN POWER CONDITIONER, SARNO's Steel Guitar BLACK BOX,BJS,ToneMaster bars,FENDER Strat, FENDER & Ovation acoustic's |
|
|
|
Rene Brosseau
From:
Chatham,Ontario, Canada
|
Posted 21 Nov 2012 2:37 pm Nice !
|
|
I have a Franklin. This is the only other guitar I would consider. This is a beauty !
_________________
Franklin #130, Melobar Skreemer, Wechter Scheerhorn Resonator, Nashville 112, Boss DD 3 |
|
|
|
Al Vesel
From:
Chisholm, Minnesota, USA
|
Posted 28 Nov 2012 8:28 am JCH SD-10 3 x 6
|
|
GUITAR HAS BEEN SOLD ON OTHER SITE !!
Bob-Please close.
Al V.
_________________
Emmons LeGrande SKH D-10 - WALKER STEREO STEEL AMP w JBL ENCLOSURES & TC ELECTRONICS M-ONE XL PROCESSOR, HILTON VP,FURMAN POWER CONDITIONER, SARNO's Steel Guitar BLACK BOX,BJS,ToneMaster bars,FENDER Strat, FENDER & Ovation acoustic's |
|
|
|
