| Author |
Topic: Pickup screws size |
jolynyk
From:
Prince Albert Sask. Canada
|
Posted 2 May 2013 10:25 am |
|
| Does anyone know what size the 4 little screws are that hold the pickup down are?? I misplaced mine as I have double sided tape holding the 705 pickup down, but it seems to be distorting a bit, & I'd like to remove the tape & put the screws in to hold the pickup..Don't want to put bigger screws in & screw up the existing holes..(no pun intended).. |
|
|
 |
Lynn Stafford
From:
Ridgefield, WA USA
|
Posted 2 May 2013 12:01 pm Pickup Mounting Screws
|
|
You didn't mention what brand of guitar you have but more than likely, you'll need some #4-40 NC-UNC screws and perhaps some spacers to fit between the bottom plate of the pickup and the mounting plate. Hopefully you're near a decent hardware store up there that stocks fastners other than metric, if I'm correct about that size.
_________________
Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
jolynyk
From:
Prince Albert Sask. Canada
|
Posted 2 May 2013 12:38 pm
|
|
| Hi Lynn, sorry it's a GFI S10.. There were no springs or adjustments on it.. Used to have a GFI II pickup on it.. It had no spacers as I recall, but just sat right on the Mica.. |
|
|
|
