Stringmaster blendknob hole size?

Ron Victoria · From: New Jersey, USA

I made some blendknobs for a member and need to drill the center hole correctly. My Fender isn't here right now. What size should I drill to fit snugly on the pot shaft?
thanks, Ron

Bill Creller · From: Saginaw, Michigan, USA (deceased)

The standard 1/4" shaft size likely. Some of the off-shore pots are different, but likely the Fender has 1/4 inch shafts.

Forum Index > Steel Without Pedals		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: