Author |
Topic: Bobbie's Fender Decals |
Hugh Holstein
From: Rohnert Park, California, USA
|
Posted 17 Feb 2012 3:47 pm
|
|
I just tried to apply one, I'm very unhappy in the quality of these, I guess I will have to make my own.
Aside from coating it with decal restoring solution does anyone have any other ideas?
It just came apart it about a hundred pieces. |
|
|
|
Peter den Hartogh
From: Cape Town, South Africa
|
|
|
|
Hugh Holstein
From: Rohnert Park, California, USA
|
Posted 17 Feb 2012 7:50 pm
|
|
I have been a model builder longer than I played music so I know how to apply water slide decals.
I was able to get it, but I had to burn up my backup decal for my next project right off the bat, oh well.
Here is some pics that show today's adventure:
Oh Noooooo!
Second attempt using decal film liquid:
Here is a N scale GP9 that I decorated about eight years ago (those are some mighty fine decals):
|
|
|
|
Peter den Hartogh
From: Cape Town, South Africa
|
Posted 17 Feb 2012 10:31 pm
|
|
Love the tracks and sleepers too! |
|
|
|
Mark Bridge
From: Tempe, Arizona, USA
|
Posted 29 Feb 2012 12:23 pm Getting ready to do the same decal...
|
|
Hugh - good timing as I'm getting ready to apply one of these to a Stringmaster D8 I'm refinishing. Being a decal amateur myself, any words of advice on using the decal liquid film and best procedure? I would greatly appreciate that. Thanks, Mark |
|
|
|
Hugh Holstein
From: Rohnert Park, California, USA
|
Posted 29 Feb 2012 3:43 pm
|
|
I used Microscale Industries Liquid Decal Film applied with a #2 sable brush, let dry.
Using the plastic board material that the decal is shipped with, I taped the very edges (only two opposing) of the decal to the board, being careful not to tape the decal itself.
I did this to reduce the amount the decal "curled" when put in the water, which I believe is a contributing factor to the decal self-destructing.
I then used Microscale Micro Set and Micro Sol to set the decal and prevent any "silvering" from it not being set all the way.
You have to be very careful with this step because the decal gets softened by the setting solution and can get damaged very easily.
The result is what I got on my second attempt above after a lot of grunting and making a fair share of strange facial expressions. |
|
|
|
Mark Bridge
From: Tempe, Arizona, USA
|
Posted 29 Feb 2012 3:47 pm That helps...
|
|
Thanks Hugh, something so easy, yet not for the faint of heart at all. I've order an extra decal, just in case... |
|
|
|