| Visit Our Catalog at SteelGuitarShopper.com |

Post new topic Knee levers fixed to the guitar, but not to the push/pull.
Reply to topic
Author Topic:  Knee levers fixed to the guitar, but not to the push/pull.
Adam Fischer

 

From:
Pennsylvania, USA
Post  Posted 1 Jul 2010 12:06 pm    
Reply with quote

I bought my pedal steel second-hand from a guy who had built it from a kit a few decades back. I believe it is a MarketRite Mark II. It has three pedals and four knee levers. Only one knee lever is currently functioning, one is attached to rods but doesn't pull to a useable pitch (while moving in one direction, it lowers the pitch and then begins to raise it again). The other two are not connected to anything other than the body itself. Pictures below to illustrate. Is this the sort of thing one who knows nothing, but wants to learn, can do? If so, where does one get parts and/or instruction? If not, where might one find someone who can?





Thanks for looking. This is a great forum, I have already learned so much here. Thanks to all for sharing what they know.
View user's profile Send private message Send e-mail
Jim Eaton


From:
Santa Susana, Ca
Post  Posted 1 Jul 2010 12:27 pm    
Reply with quote

It looks to me like the 2 KL's that are not hooked up to anything would be of a "reversing" type. Normally there would be a short rod from the KL to an "Idler" crank also attached to the rear apron and another short rod from the "idler crank" to a bell crank on a cross shaft that would then have pull rods attached to bell cranks for the changes that are worked by that lever. I think that both are KL's that move to the right if I'm looking at your photos correctly and the "idler crank" is used to "reverse" the pulling motion away from the changer.
JE:-)>
View user's profile Send private message Send e-mail

All times are GMT - 8 Hours
Jump to:  
Please review our Forum Rules and Policies
Our Online Catalog
Strings, CDs, instruction, and steel guitar accessories
www.SteelGuitarShopper.com

The Steel Guitar Forum
148 S. Cloverdale Blvd.
Cloverdale, CA 95425 USA

Click Here to Send a Donation

Email SteelGuitarForum@gmail.com for technical support.


BIAB Styles
Ray Price Shuffles for Band-in-a-Box
by Jim Baron